LEXUS RX 300

1998 - 2003 of launch

Repair and operation of the car


Lexus RX 300
+ Lexus RX-300 cars
+ Administrations and methods of operation
+ Placing and regular maintenance of the car
+ Motor
- Cooling systems of the motor, heating, ventilation and air conditioning
   - System of cooling of motor
      Information general and measured by precaution
      Removal, check and installation of the water bomb
      Removal, check and installation of the thermostat
      Check of component ones of the system of cooling
      Removal and installation of an electric heater and supporters
   + Systems of heating, ventilation and air conditioning
+ A system of provision of power and production of the carried out gases
+ Systems of electric equipment of the motor
+ Automatic exchange and differential interaxal
+ Transmission line
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment
+ Schematic diagrams of electric connections
8ca8824c

Removal and installation of an electric heater and supporters

Component final access to an electric heater

1 - the Superior covering of an electric heater
2 - the Condenser K/V
3 - the Lowest front guard
4 - the Digit hose
5 - Quencher of front punch of bumpers

6 - the Digit tube
7 - the Capture of an electrical system of a light of marker of side
8 - the List of bumpers front line player
9 - Nizhny Novgorod a covering of a compartment of reason

Component of fixation and connection of an electric heater

1 - an electric heater Covering
2 - the Superior support of an electric heater
3 - Meeting of an electric heater
4 - the Capture n ° 1 of supporter
5 - the Drain cork
6 - the Lowest support of an electric heater
7 - the Fighter ring

8 - the Capture n ° 2 of supporter
9 - the ECT n ° 1 of Capture D/V
10 - the Hose of a wide tank of OZh
11 - the Best hose of an electric heater
12 - Hose of fridge of ATF
13 - Nizhny Novgorod an electric heater hose

Supporters' Fastenings to an electric heater

Meeting of an electric heater

1 - an electric heater Covering
2 - the Best tank
3 - the Fighter ring
4 - the heat Conductor
5 - the Tube
6 - the Nut

7 - the Lavador
8 - the Drain cork
9 - Nizhny Novgorod a tank
10 - the Oil fridge
11 - ECT N ° 1 D/V

Supporters' meeting

 ORDER OF REALIZATION

  1. Withdraw more low a covering of a compartment of reason.
  2. Empty the system of cooling (to see the Substitution of Section of Cooling Liquid (CL)).
  3. Desconecte the next captures and hoses of an electric heater:
    • Taken (n ° 1 and n ° 2) of supporters;
    • ECT n ° 1 of capture of D/V;
    • The top and the lowest hoses of an electric heater;
    • Two hoses of the fridge of oil of an electric heater;
    • Result two pins and two withdraws superior support of an electric heater.
  4. Lift the meeting of an electric heater and lower support withdraws it of two.
  5. Result 6 pins and withdraw the supporters' meeting of an electric heater.
  6. A supporters' krylchatok gives to fixation nuts and withdraw krylchatka.
  1. Desconecte a wire and the bearer of the capture of a supporters' covering, results three screws and withdraw э / supporters' motors.
  1. The installation is done as it must be, the return to an order of is demolished of component ones. Hold tight the whole fixation with the necessary efforts. Pile up an electrical system so that it did not concern movable elements.