LEXUS RX 300

1998 - 2003 of launch

Removal, desmontagem, meeting and installation of a torture of a support of the triangular form of interruption

Component of a torture of a rear support of the triangular form of interruption


1 - the Covering of a dome of a support they are resistant 2 - the Capture 3 - the Hat 4 - an Emphasis of torture of support of the triangular form of interruption 5 - the Damper 6 - the spring of Screw	7 - the Lowest saddle of one spring 8 - Meeting of a torture of a rear support of the triangular form of interruption 9 - a Torture of stabilizer of support of the triangular form of interruption 10 - the Flexible hose 11 - the absorbent of the Shock 12 - Sketch of the sensor of agreement of an inclination of lighthouses 13 - Electrical system of sensor of speed of ABS

Removal and desmontagem

ORDER OF REALIZATION

Discover domes of a support of a support of the triangular form of interruption and the corresponding wheel.
In the corresponding complete set they turn a nut and desconectam the thirst of the sensor of the agreement of an inclination of lighthouses of the angry lever n ° 2 of a rear support of the triangular form of interruption.
A pin results and remove of a torture the bearer of an electrical system of the sensor of the speed of ABS.
A pin results and remove of a support of the triangular form of torture the bearer of a hose of flexible brake.
A nut results and desconecte a torture of stabilizer of the absorbent one of the shock.

If the hinge is turned together with a nut, a key of six sides maintains it in 5 mm.

One weakens, two nuts of the fixation are resistant supports of the triangular form of interruption to the meeting stupichny.

Still do not take pins.

Support the meeting stupichny for a monkey and take away a hat of an emphasis of torture of support of the triangular form of interruption.
In the necessity of the desmontagem of a torture they are weakened, but they do not give the completely superior nut (central office) of the fixation of one spring.
Result three superior nuts of the fixation of a torture.
Omit the meeting stupichny and withdraw two pins lower of the fixation of a torture.
Withdraw the meeting of a torture of a rear support of the triangular form of interruption.
Establish two pins with nuts in the inferior arm of the fixation of a torture and hold tight it in a vice.
Through the special adaptation they hold tight one spring and, completely they result a nut of the fixation of one spring
Withdraw the capture, an emphasis of torture, the pressed spring, a damper and the lowest saddle of one spring.
To press and to spread out a stick of the absorbent one of the shock are secured of smoothness of his course and lack of exceptional sounds. In unsatisfactory results of the check they substitute the absorbent of the shock.

Meeting and installation

ORDER OF REALIZATION

Establish the lowest saddle of one spring and a damper.
Through the special adaptation they hold tight a spring of screw and install it in the absorbent one of the shock.

More low the circle of one spring will rest against a groove of the lowest saddle.

An emphasis of a torture is level with the support of triangular form more low than the absorbent one of the shock.

Installation of an emphasis of a torture

1 - the support of triangular form more Low
2 - a torture Emphasis

Install the capture and temporarily hold tight a nut of the fixation of one spring.
Adaptation of one spring withdraws the tug together and check the direction of an emphasis of a torture.
The installation is done upside-down.