LEXUS RX 300

1998 - 2003 of launch

Repair and operation of the car

Lexus RX 300
+ Lexus RX-300 cars
+ Administrations and methods of operation
+ Placing and regular maintenance of the car
+ Motor
+ Cooling systems of the motor, heating, ventilation and air conditioning
+ A system of provision of power and production of the carried out gases
+ Systems of electric equipment of the motor
+ Automatic exchange and differential interaxal
+ Transmission line
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
- Electric side equipment
   General information
   Diagnostic of bad functioning of electric equipment of side - the general information
   Locks of security - the general information
   The alternation - the general information and check of usefulness of functioning
   Protect lavadores of windshield and clothes to rub
   Substitution of lamps of incandescence
   Removal and installation of a covering of a column of direction and switches of understeering
   Check of usefulness of functioning of some auxiliary systems
   Removal and installation of the antenna
   Removal and installation of a combination of devices
   Agreement of an inclination of lighthouses
   Removal and installation of component ones of the men's system
   Removal and installation of component ones of regulators of window and clothes to rub of fabric
+ Schematic diagrams of electric connections

Removal and installation of a combination of devices

Component of meeting of a combination of devices


1 - the rear Cape 2 - ECU to / in and devices combinations 3 - Contacts 4 - the Payment 5 - the Case	6 - Plastina 7 - Meeting of a speedometer 8 - the Advanced insertion 9 - the Lamp 10 - Protective glass

ORDER OF REALIZATION

Result 9 screws and withdraw a rear cape of a combination of devices.
Result 4 pins, withdraw the ECU and 2 plays of contacts.
Result 4 screws, separate 6 captures and withdraw the printed circuit of the case.

Withdraw an advanced insertion and protective glass.
The screw results and withdraw a plate.
Result 2 screws and withdraw the meeting of a speedometer.
The installation is done upside-down.