LEXUS RX 300

1998 - 2003 of launch

Repair and operation of the car


Lexus RX 300
+ Lexus RX-300 cars
+ Administrations and methods of operation
+ Placing and regular maintenance of the car
+ Motor
+ Cooling systems of the motor, heating, ventilation and air conditioning
+ A system of provision of power and production of the carried out gases
+ Systems of electric equipment of the motor
- Automatic exchange and differential interaxal
   General information
   Inquiry of bad functioning - the general information
   Sensors substitution
   Removal and installation of meeting of in valves
   Checks and agreements of in
   Removal and installation of a fridge of ATF
   Removal and installation of meeting of the lever of the selector of IN ways
   Removal and DURING installation
+ Transmission line
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment
+ Schematic diagrams of electric connections
8ca8824c

Removal and installation of meeting of in valves

 ORDER OF REALIZATION

  1. Withdraw the covering of protection more low of a reason compartment, there results a cork of drain and emptiness in.
  1. Result 18 pins of the fixation of the trundle bed of a case of in, withdraw the trundle bed and desconecte of him the placing.
  2. Withdraw magnetos and one joins with his help metal particles of in the case TRUNDLE BED. Examine metal particles in a magneto and in the trundle bed – the particles from steel that (they are magnetized) indicate the use of loads, wheels of gear and lavadores, but when the captures use was not magnetized (copper or brass)–.
  1. Result 3 pins and withdraw a maslozabornik with a fighter ring.
  1. Separate captures of five Ý/m valves call.
  2. A pin results, withdraw a plate of lock and withdraw the sensor of temperature ATF (to see the Substitution of Section of Sensors).
  3. Launch an electrical system of two bearers.
  1. Result 17 pins and withdraw the meeting of valves.

Do not leave the meeting of the valve of control, one spring and the piston of the accumulator.


  1. Withdraw the case of the valve of control, one spring and three placing.
  1. Result 5 pins and withdraw 5 Ý/m valves call.
  1. The installation is done as it must be, the return to an order of is demolished of component ones, holds tight the fixation with the necessary efforts, uses the new placing and the hunting of rings.