LEXUS RX 300

1998 - 2003 of launch

Repair and operation of the car


Lexus RX 300
+ Lexus RX-300 cars
+ Administrations and methods of operation
+ Placing and regular maintenance of the car
+ Motor
+ Cooling systems of the motor, heating, ventilation and air conditioning
+ A system of provision of power and production of the carried out gases
+ Systems of electric equipment of the motor
- Automatic exchange and differential interaxal
   General information
   Inquiry of bad functioning - the general information
   Sensors substitution
   Removal and installation of meeting of in valves
   Checks and agreements of in
   Removal and installation of a fridge of ATF
   Removal and installation of meeting of the lever of the selector of IN ways
   Removal and DURING installation
+ Transmission line
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment
+ Schematic diagrams of electric connections
8ca8824c

Removal and DURING installation

Component of DURING installation (U140F)

1 - the Braid and captures of an electrical system
2 - a weight Thread
3 - the Right support
4 - the Right torture of a tube of leak
5 - Transmission

6 - an initial Cork of measurement of pressure in IN lines
7 - the Author
8 - the Left torture of a tube of leak
9 - the Lowest covering of a disc of driving


 ORDER OF REALIZATION

  1. Withdraw the unity of power of the car (installation of the motor sees the Removal of Section e a, checks of the support).
  2. Remove an author (installation of an author sees the Removal of Section e a).
  3. Result pins and nuts and withdraw the left and right tortures of a tube of leak.
  4. Result 5 pins and withdraw the right support.
  5. Result 2 pins to covering lower of a disc of driving.
  6. Becoming an end of inclination, result pins of the fixation of the union of the hydrotransformer.
  1. Result three pins lower of the fixation of in.
  1. Result pins of the fixation of threads of the weight her in and desconecte these threads.
  2. Desconecte the next captures of in:
    • When way was taken of D/V of P / N;
    • When valve was taken of electrical system of Ý/m;
    • Taken of the sensor of turns of entry of the hydrotransformer;
    • Taken of the sensor of speed of a wheel of auxiliary gear.
  3. Launch a braid of bearers' electrical system.
  4. Result 5 superior pins of the fixation of in and desconecte a weight thread.
  5. Withdraw in.
  6. The installation is done upside-down. Hold tight the fixation with the necessary effort.
  7. After the installation they adjust the walk of the dislocation of gear and D/V of P / N ways. Fill in of the liquid ATF, check his level. Do a travel of proof in the car.