LEXUS RX 300

1998 - 2003 of launch

Repair and operation of the car


Lexus RX 300
+ Lexus RX-300 cars
+ Administrations and methods of operation
+ Placing and regular maintenance of the car
+ Motor
+ Cooling systems of the motor, heating, ventilation and air conditioning
+ A system of provision of power and production of the carried out gases
+ Systems of electric equipment of the motor
+ Automatic exchange and differential interaxal
+ Transmission line
+ Brakes system
- Support of the triangular form of interruption and direction
   General information
   + Dispatch the support of the triangular form of interruption
   + Support of the triangular form of subsequent interruption
   + Direction
   - Geometry of support of the triangular form of interruption
      The angles of installation of wheels of the car - the general information
      Check and adjust of angles of installation of advanced wheels
      Check and agreements of angles of installation of rear wheels
+ Body
+ Electric side equipment
+ Schematic diagrams of electric connections
8ca8824c

Check and agreements of angles of installation of rear wheels

To check

 ORDER OF REALIZATION

  1. The height of support of the triangular form of interruption of measure (to see the Check of Section e o adjusts of angles of the installation of advanced wheels).
  2. Install the car in the bookcase of measuring and check the disorder and the convergence of rear wheels.
  3. If the size of the disorder is not adapted with demands of Specifications of the Chief Podvesk and direction, check component of support of the triangular form of interruption the existence of damages and use.

The disorder of rear wheels is not regulated.

  1. If the size of the convergence is not adapted with demands of Specifications of the Chief Podvesk and direction, adjust the convergence.

Convergence agreement

 ORDER OF REALIZATION

  1. Distance of measure of a disc of each rear wheel to a corner of a clown of agreement of convergence.
  1. It distinguishes one between the distances measured more than 3,0 mm, weaken a pin of the clown and turn the clown in the demanded corner of the installation of the middle value of specification of the convergence.
  1. After the agreement they hold tight a pin with the effort of 113 nanômetros.