LEXUS RX 300

1998 - 2003 of launch

Repair and operation of the car

Lexus RX 300
+ Lexus RX-300 cars
+ Administrations and methods of operation
+ Placing and regular maintenance of the car
- Motor
   General information and preparatory operations
   Check of pressure of compression
   Check of the motor through the vacuum measure
   Reduction of the piston of the first cylinder in the provision of the superior dead point (TDP)
   Check of a corner of an advancement of ignition
   Removal, check and installation of a belt of GRM drive of his natyazhitel, pulley and cog-wheel of an end of inclination, cog-wheels of axles and intermediary rolls
   Removal, desmontagem, checks, meeting and installation of a head of cylinders and his component
   Removal and installation of the motor, check of support
   Cylinder block
   Check of D/V of pressure of oil of reason
   Removal, desmontagem, checks, meeting and installation of the bomb of oil and trundle bed of a case
+ Cooling systems of the motor, heating, ventilation and air conditioning
+ A system of provision of power and production of the carried out gases
+ Systems of electric equipment of the motor
+ Automatic exchange and differential interaxal
+ Transmission line
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment
+ Schematic diagrams of electric connections

Check of a corner of an advancement of ignition

The corner of an advancement of the ignition the ECU defines for and it is not subject to the manual agreement.

ORDER OF REALIZATION

Withdraw a decorative covering of the motor, having resulted 3 nuts of his fixation and having withdrawn his armbands.

Heat the motor up to the temperature of normal work.

The scanner OBD-II joins n ° 3 been overcome with DLC, which is guided for the education of the producer of the scanner.

A clip adheres of estroboscópio to a wire conclusion.

Increase turns of motor to 2.500 revolutions per minute approximately during 90 seconds and check what wastes time you return – they will make 50 revolutions 700 ± per minute. Leave the motor to work in the only turns.

Checking turns of wasting time the next conditions they have to be satisfied:

The motor has to be heated;

The air purifier has to be installed, and the air hoses and the tubes will be that you were spinning and will be joined correctly;

The whole additional equipment has to be put out;

All the vacuum lines will be that you were spinning and will be joined correctly;

The captures of an electrical system of the system of the injection have to be joined confiantemente;

The check of a corner of an advancement of the ignition will satisfy conditions of Specifications of the Chief Dvigatel;

IN tem of be establishing in the neutral situation.

You turn them of wasting time not to be adapted with demands of Specifications of the Chief Dvigatel, check the valve IAC and a way airintaking.

The contacts of the TE1 and capture E1 DLC n ° 1 also establish the Peremknita in in the neutral situation.

When drive illuminated with an estroboscópio a scale in a covering of belt of GRM, it thinks an ignition an advanced corner.

1 withdraws a point of passage of the capture DLC n ° and advanced corner re-examines an ignition.

Compare the values received with demands of Specifications of the Chief Dvigatel.

Desconecte an estroboscópio and the scanner OBD-II.

Establish a decorative covering of the motor.