LEXUS RX 300

1998 - 2003 of launch

Repair and operation of the car


Lexus RX 300
+ Lexus RX-300 cars
+ Administrations and methods of operation
+ Placing and regular maintenance of the car
+ Motor
+ Cooling systems of the motor, heating, ventilation and air conditioning
+ A system of provision of power and production of the carried out gases
+ Systems of electric equipment of the motor
+ Automatic exchange and differential interaxal
+ Transmission line
- Brakes system
   General information and measures of security
   Removal, installation and check of pedals of the system of brakes
   Check of the system of brakes was seeing the capture of the module of management
   Removal and installation of the tank and cylinder of main brake (MBC)
   Removal, check and installation of the amplifier of brakes
   Substitution of shoes of brake
   Removal, desmontagem, checks, meeting and installation of supports of mechanisms of brake
   Being demolished, check and the meeting of the brake of parking
   Check of valve of distribution of effort of brake
   Removal and installation of the activator of brakes
   Removal and installation of sensors of wheel
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment
+ Schematic diagrams of electric connections
8ca8824c

Removal and installation of the activator of brakes

Component of installation and meeting of the activator

1 - the Wide tank of OZh
2 - Meeting of the activator
3 - tube of GUR
4 - Activator

5 - the Bearer
6 - Placing
7 - Loker of the right dispatches the arch of wheel
8 - the Arm of fixation of the activator


 ORDER OF REALIZATION

  1. Withdraw the right advanced wheel and a drawer with lock of his arch.
  2. There results a pin of the fixation of the bearer of a tube of GUR.
  3. Move a wide tank of OZh they dispatch it and withdraw it to a bearer.
  4. Separate the 4th capture and desconecte hoses of the activator of brakes.
  5. Desconecte of the meeting of the activator of brakes of 6 tubes of brake.
  6. Two pins and a nut results and withdraw the meeting of the activator.
  7. Result two nuts and withdraw the activator of an arm.
  8. Two bearers and three withdraws of the activator placing.
  9. The installation is done upside-down.
  10. After the installation they fill the tank GTTs of the fluid of brake and bomb on the system of brakes (to see the Substitution of Section of Fluid of Brake, the extraction through bomb of the system of brakes).