Lexus RX 300
+ Lexus RX-300 cars
+ Administrations and methods of operation
+ Placing and regular maintenance of the car
+ Motor
+ Cooling systems of the motor, heating, ventilation and air conditioning
+ A system of provision of power and production of the carried out gases
+ Systems of electric equipment of the motor
+ Automatic exchange and differential interaxal
+ Transmission line
- Brakes system
General information and measures of security
Removal, installation and check of pedals of the system of brakes
Check of the system of brakes was seeing the capture of the module of management
Removal and installation of the tank and cylinder of main brake (MBC)
Removal, check and installation of the amplifier of brakes
Substitution of shoes of brake
Removal, desmontagem, checks, meeting and installation of supports of mechanisms of brake
Being demolished, check and the meeting of the brake of parking
Check of valve of distribution of effort of brake
Removal and installation of the activator of brakes
Removal and installation of sensors of wheel
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment
+ Schematic diagrams of electric connections
|
Removal, check and installation of the amplifier of brakes
Component of installation of the amplifier of vacuum of brakes
To check
|
|
- Several times hold tight out a pedal of a brake of work in the motor off and it is secured what the course of a pedal does not modify.
- Hold tight out a pedal of a brake and the motor begins. If the pedal slowly falls, the vacuum amplifier is useful.
- The motor begins and deaden it for 1÷2 I draft. Slowly several times hold tight out a pedal of brake. If the first time corsets itself the pedal deeply, and in the second or third attempt his course gradually lessens, the amplifier is held tight.
- In the pressure of motor of work it had been a pedal of a brake and, without launching it, they kill the motor. In the confirmation of the tension of the amplifier of vacuum the pedal must not modify the course during 30 seconds of his care.
|
|
Removal
Installation
|
|
- Establish the amplifier with the new placing.
- Establish a support of triangular form in a stick of the amplifier.
- Hold tight nuts of the fixation of the amplifier with the effort of 13 nanômetros.
- Insert a pin in a support of triangular form and a pedal of a brake of work and the quiff registers it.
- Establish a repayable spring of a pedal of a brake.
- Establish the new placing in GTTs.
|
|
- Install the special adaptation in placing and nucleus of adaptation more low up to a contact with the piston.
|
|
|
- Withdraw the special adaptation of GTTs and establish in the amplifier.
|
- Measure a slit between a stick of the amplifier and a nucleus of the special adaptation, - it will do 0 mm.
- Adjust an edge of a stick of the amplifier so that his end lightly concerned a nucleus of the special adaptation.
|
|
There does the agreement the absence of the negative pressure annexed to the amplifier (with this finality in the dead pressure the time had been a pedal of brake in order that the pressure had been level in the amplifier with the atmospheric pressure). |
- Establish GTTs, join a hose of vacuum to the amplifier, register lines of brake in the bearer.
- Fill the tank of the fluid of brake, bomb on the brakes system and check it holes.
- Adjust a pedal of a brake of work (to see the Check of Section e o adjusts of the course of pedals of the work and parking brake). Do a travel of proof.
|
|
|
|
