LEXUS RX 300

1998 - 2003 of launch

Repair and operation of the car

Lexus RX 300
+ Lexus RX-300 cars
+ Administrations and methods of operation
+ Placing and regular maintenance of the car
+ Motor
+ Cooling systems of the motor, heating, ventilation and air conditioning
+ A system of provision of power and production of the carried out gases
+ Systems of electric equipment of the motor
+ Automatic exchange and differential interaxal
+ Transmission line
+ Brakes system
- Support of the triangular form of interruption and direction
   General information
   - Dispatch the support of the triangular form of interruption
      Removal, desmontagem, meeting and installation of a nave and rotary fist
      Removal, demolishing meeting and installation of a torture of a support of the triangular form of interruption
      Removal and installation of the lowest lever of a support of the triangular form of interruption
      Check and substitution of a spherical support of a support of the triangular form of interruption
      Removal, installation and check of the stabilizer of a support of the triangular form of interruption
   + Support of the triangular form of subsequent interruption
   + Direction
   + Geometry of support of the triangular form of interruption
+ Body
+ Electric side equipment
+ Schematic diagrams of electric connections

Removal, installation and check of the stabilizer of a support of the triangular form of interruption

Component of installation of the stabilizer of an advanced support of the triangular form of interruption


1 - a stabilizer Torture 2 - the Support of triangular form 3 - the Capture	4 - a capture Cork 5 - the support of triangular form n ° 2 6 - the Bearer of a cork

ORDER OF REALIZATION

Withdraw both advanced wheels.
Result two nuts of each party and withdraw both tortures of the stabilizer (in series).

If the hinges are turned together with nuts, they maintain them a key of six sides in 5 mm.

In series turn two pins and withdraw supports of triangular form and captures of the stabilizer.
Withdraw the stabilizer.
Through the screwdriver they remove the bearer of a cork of the capture, and soon they withdraw a cork.

Hold tight the hinge of a torture of the stabilizer in a vice and shake his tip ahead and backwards approximately five times.

Continuously when a hinge nut is holding tight a key of dynamometer with a speed of 1 a turn of 2 ÷ 4 with, consider indications of a key in the fifth turn and compare them with demands of Specifications of the Chief Podvesk and direction. If necessary a stabilizer torture substitutes.
The installation is done upside-down. Install the capture of the stabilizer on the outside of a capture cork; install the stabilizer for the party marked with the painting to the left council of the car.