LEXUS RX 300

1998 - 2003 of launch

Repair and operation of the car

General information on placing and agreements

"The placing" in the present manual is destined how not the proceeding separately been overcome with the correction of the car, some of parameters of systems and the whole complex of the agreements that they allow to carry out the very efficiency of the return of the motor.

If the owner of the new car from the day of his acquisition strictly joined to the time-table of proceedings of the regular maintenance (to see the Time-table of Section of the Regular Maintenance), somewhat very often was executing checks of critical parameters, supported the necessary level of lubricating liquids, the motor will need extremely rarely realization of the additional service and repair of recuperation (on the substitution subject to the increased use of component ones and expendables).

From another side, in case of the negligent relation the artistic proceedings of regular maintenance and violation of established periods of carrying out controls, the efficiency of the return of the motor will lessen certainly sooner or later. The probability of the emergence of such situation in case of the acquisition of the car that was in the use is specially high. In such cases it is a need for the realization of a complex of placing of the unity to be able on the amount of works in the regular maintenance of the car.

The first step in control or diagnostic of bad functioning that work with the lowered return of motor it is always the check of the pressure of compression in cylinders (the Chief Dvigatel sees) which results analysis allows to appreciate the general condition of internal component ones of the motor and to write the plan of the work of recuperation and / or adjust near. For example, if the check of the pressure of compression revealed signs of the serious internal use of the motor, there will be not enough usual placing complex to correct a situation, and his realization will be a waste of time and a half. In view of the value of the information obtained as a consequence of the check of the pressure of compression, his realization must be accused to a quite experienced one and it qualified the mechanic who has necessary diagnostic unities.

The lists of the main proceedings of agreement that they allow to carry out the very efficiency of the return of the motor that is in a mechanical work order happen down.

List of the least complex of checks and agreements

• Check levels and existence of the hole of liquids of work (to see the Check of Section of Levels of Liquids, control of holes);
• Check a condition of the battery recarregável and if necessary it compensates for his captures (to see the Check of Section of a Condition of the Battery and to Leave It backwards);
• Check all the hoses located in a compartment of reason, tubes and an electrical system of the existence of holes and use (to see the Check of Section of a state and the Substitution of Hoses of a Compartment of Reason, location of holes);
• Check the height of a protector and the pressure of an evaluation of tires, including a wheel of surplus (to see the Check of Section of a Condition of Tires and the Pressure of your Evaluation, rotation of wheels);
• Check the usefulness of the functioning of all the consumers of the electric power (illuminating fixations, cheat, control lamps, etc.) (to see the Check of Section of the Operabilidade of Illuminating Fixations, a horn and the supporter of a heater).