LEXUS RX 300

1998 - 2003 of launch

Repair and operation of the car



Lexus RX 300
+ Lexus RX-300 cars
+ Administrations and methods of operation
- Placing and regular maintenance of the car
   General information
   General information on placing and agreements
   Time-table of regular maintenance
   Check of levels of liquids, control of holes
   Check of a condition of tires and pressure of his evaluation, rotation of wheels
   Substitution of filter of oil of reason and filter of oil
   General checks of the system of brakes
   Check and substitution of the filter of hall of a heater and to / in
   Check of a state and substitution of hoses of a compartment of reason, location of holes
   Check of a state and substitution of belts of the walk of auxiliary unities
   Substitution of the element of purifier of air of filtration
   Check of a condition of system of production of the carried out gases
   Check and substitution of captures of spark
   Substitution of fluid of brake, extraction through bomb of the system of brakes
   Check of a condition of component ones of a support of the triangular form of interruption and direction
   Check of a condition of protective coverings of ends of power and hinges of the driving axle
   The check of the operabilidade of there illuminate fixations, horn and supporter of a heater
   Check of the system EVAP
   Check of a state, agreement and substitution of brushes from clothes to rub of fabric
   His check of a condition of the battery and care
   Substitution of the cooling of liquid (CL)
   Check and adjust of slits valvate
   Check and adjust of the course of pedals of the work and parking brake
   Check of boots of the brake of parking
+ Motor
+ Cooling systems of the motor, heating, ventilation and air conditioning
+ A system of provision of power and production of the carried out gases
+ Systems of electric equipment of the motor
+ Automatic exchange and differential interaxal
+ Transmission line
+ Brakes system
+ Support of the triangular form of interruption and direction
+ Body
+ Electric side equipment
+ Schematic diagrams of electric connections

8ca8824c

Substitution of filter of oil of reason and filter of oil

The long contact from the skin with the oil of carried out reason is quite dangerous. Use the protective cream or put gloves of rubber during the proceedings described down.


The frequent substitution of oil of reason is the main preventive proceeding of the service, to an available amateur mechanic. Consequently the oil is subject to fluidifying and pollution that leads to the premature use of the motor.

Afundamento of oil of reason

The reason oil can be pumped out through the probe by the tube of probe of direction.


 ORDER OF REALIZATION

  1. Heat the motor up to the work temperature of cooling the liquid.
  2. The car also establishes it the Poddomkratta in stakes or exhausts in an observation hole.
  3. Substitute below a capacity of cork of drain approximately 6 l to join the carried out oil.
  1. A drain cork results and oil flow leaves us I lower completely.

Do not burn a hand with the next heated oil!

  1. Check a condition of the carried out oil. If in him there are in a great number a metal shave and the products of the use, it indicates the existence of zadir, for example, in loads of an end of inclination and loads conrod. For a damages exception after the done repairs it is necessary to compensate for channels carefully of oil and hoses, and also, in the corresponding complete set, to substitute the fridge of oil.

Substitution of a filter of oil

 ORDER OF REALIZATION

  1. There results a filter of oil of a flange. With this finality it is possible to use the special adaptation or a key of strip. Also it is possible to insert the sharp screwdriver for a side in the filter, at the same time the oil, therefore, in advance substitutes for the capacity since the oil is joined below the filter it will begin to follow of the filter.
  1. Rub a surface of a filter of oil and his flange in the cylinder block and withdraw the placing of fighter if it remained in a flange.
  2. Placing of fighter of fat of a new filter of oil with oil of pure reason.
  3. Screw a new filter of oil to the hand. After the placing is going to be laid to a flange in the cylinder block, the filter will insist on three rooms of a turn. Pay attention to the observations given in case of filter.

Stuffing of the motor with oil

When it substitutes it it is necessary to use the oil of identic type and, whenever possible, identic mark. It is recommended in spite of fixing this finality in each oil substitution in the motor an etiquette with the indication of the mark and viscosity of oil. The oils of reason of identic type and identic marks, but they can fill out different viscosity during the time seized the year.


 ORDER OF REALIZATION

  1. Twist a cork of woodcarving of a drain that opens in a new hunting they touch and hold tight it with the effort of 45 nanômetros.
  2. Discover a gooey mouth and fill out the oil of reason approximately in the half of the liter less, of which it is specified in Specifications (to see the Check of Section of Levels of Liquids, control of holes).
  3. The motor begins and leave us that it works wasting time, having checked the existence of the hole of oil of reason meantime.
  4. Wait during 5 minutes, soon check the level of oil and if necessary it modifies it.
  5. Do a travel of proof in the car and check a cork of drain and a filter of oil of holes. If necessary, carefully raise them. Re-examine the level of oil, if necessary it modifies it.